There are lots of puzzles to choose from you today. Images of beach scenes between all the mountains, the avant-garde art masterpieces of printing, and more. Not only is there a difference in the number of scenes that you can choose, there are also a variety of shapes and sizes available limit. Puzzles are a fun challenge together. You can also a very nice gift. Here's a way to preserve them, in order to establish thatGift.
MATERIALS
A puzzle
Craft 2 brushes
(If you are planning a sponge brush to wash with soap and water, dried and reused for the next layer of paint)
1 large roll of paper (tan cheap painter's tape)
2 pieces of flat cardboard (about 2 "larger than the expected size of the puzzle finished)
Decoupage liquid (sold in an industrial area)
NOTES
1) Decide what the puzzle would be betteraccording to the interests of the person receiving the gift.
2) Put the puzzle together on a flat piece of cardboard. Find a place where it could be half as usually it takes a little 'to fully connect the puzzle.
3) If the puzzle is ready, brush dry completely to decoupage over the entire top surface image and leave. Make sure you get the decoupage liquid into the cracks between the pieces. This acts as a sealed surface and helpsGlue the pieces together. Decoupage dries fairly quickly and dries to a bright surface.
4) Place the other piece of cardboard on the puzzle plate dry.
5) Glue the top and bottom edges piece of cardboard together at various points on all edges. The finished puzzle is then between two pieces of cardboard are trapped. give some pieces of tape here and there, keep the puzzle in tact until it is overturned.
6)Accurately and quickly turn the cardboard glued / Puzzle / cardboard on the opposite side. The finished puzzle should now show the back of the puzzle.
7) Carefully remove the tape and remove the top piece of cardboard.
8) Cover the entire back of the puzzle vertically with adhesive tape. Gently press and clean the glue, so it should stay. Then repeat the entire surface again masking tape horizontally across the puzzle (tape to tape). And again,from the tape through the puzzle, pressure and friction as you go. You should now be able to bring a piece of the puzzle. However, if you want to be careful, but the other piece of cardboard again at the head of the puzzle. Then rotate the box / puzzle / board trio again. There is no need to tape the edges back in front of mirrors this time.
9) Now that the puzzle shooting the image on this page shows once again, to paint the decoupage on the surface again. Ensuredecoupage liquid to get into the cracks between the pieces. let dry completely and paint the picture of this page using decoupage again. Allow to dry completely.
10) Structure of the puzzle, like any other image.
NOTE: The puzzle is a gift of shared memories and when the person will also help you along. Just surprise then glued together and will be designed.
No comments:
Post a Comment